In recent years, the cost of industrial waste treatment has been much higher than that of domestic waste treatment. In the past, some factories were unclear about relevant compliance requirements and handed over industrial waste to lower priced domestic waste cleaning and transportation companies for disposal. In fact, there is a big difference between industrial waste and household waste. If industrial waste is put into a household waste incinerator, it cannot be completely burned out. Industrial waste that cannot be burned out can only be used as slag for landfill, which has extremely adverse environmental impacts. Due to environmental considerations, the regulation of industrial waste treatment is becoming increasingly strict, and no cleaning and transportation company dares to accept industrial waste anymore. This has also led to many factories piling up industrial waste into small hills, not only affecting visibility and occupying space, but also attracting investigation and punishment from environmental protection departments.

             Holy Shield has served many customers who have accumulated mountains of garbage similar to the above, and the problems they encounter are mostly difficult to handle. And we will conduct specific analysis based on the actual situation and waste treatment volume of each customer's factory. Adapt to local conditions and implement precise policies to develop and manufacture waste incinerators that meet the actual needs of factories. This industrial waste incinerator, despite its small footprint, has a high waste treatment efficiency! It adopts a high-temperature pyrolysis gasification process, and the temperature inside the furnace can reach 850 degrees during incineration. Most industrial waste entering the furnace can be fully and thoroughly incinerated, and the ash residue rate after incineration can be less than 5%! Once the factory waste that was originally piled up like a mountain is treated in this type of garbage incinerator, it becomes a small amount of ash. As for the issue of smoke and odor that some bosses are concerned about, this small industrial waste incinerator can also handle it very well. It has a primary and secondary combustion chamber design, and with the cooperation of high temperature and incinerator technology, all smoke and odor generated during incineration have been purified and treated, and the emissions comply with local relevant standards.