Recently, many customers have inquired about the installation and commissioning of hospital sewage treatment equipment.The following shows you the installation and debugging process of Holy Shield related equipment.

In fact, the installation of hospital sewage treatment equipment is not troublesome, and the main installation and use devices are water inlet pipe, water outlet pipe and power supply. First, find a suitable space to place the equipment, install and use the water inlet pipe, connect the sewage source water pipe, and flow into the water collection tank by itself. Connect the outlet hose to the sewer or cesspool. After plugging in the power supply (220V), test whether the leaking plug is normal. Check whether there is filter cotton in the original water tank. After opening the bolts, lay them on the filter cotton box, and finally check whether the pipes are leaking.The device operates automatically when powered on. First check whether the liquid level control is normal, open the sewage source until the water outlet flows out, close the sewage source and the water supply, and whether the equipment operation stops for 10 minutes. After normal operation, you can proceed to the next step.

During the operation of the sand filter tank, the iron wrench of the sand filter tank valve can be pulled left and right. In normal operation, the arrow points to the filter. When the equipment runs for about 10 days, pull the wrench to the forward wash for 5 minutes and backwash for 5 minutes. After rinsing, pull it back to the filter position. Replace the filter.

Above is a demonstration of Holy Shield hospital sewage treatment equipment. We have always focused on the environmental protection of wastewater, and developed a variety of sewage treatment equipment. You are welcome to leave a message below about the products you want to purchase or the solutions you want to get.